Monday, 16 June 2014

Network Theorems


Network Terminologies

Network- Any arrangement of the various electrical energy sources along with the different circuit elements.

Network Element - Any individual circuit element with two terminals which can be connected to other circuit elements.

Active Element - The elements which supply power or energy to the network. Ex: voltage source, current source.

Passive Element - The elements which either store energy or dissipate energy. Ex: resistor, capacitor, inductor.

Node - A point at which two or more elements are joined together.

Branch - A part of network which connects the various points of network.

Classification of Electrical Networks

Linear Network - A network whose parameters i.e. elements like resistances, inductance and capacitance are always constant irrespective of the change in time, voltage, temperature etc. Ohm’s law can be applied. 

Non Linear Network - A circuit whose parameters change their values with change in time, temperature, voltage etc. Ohm’s law cannot be applied. Ex: diode (characteristics depends on temperature).

Bilateral Network - A circuit whose characteristics, behavior is same irrespective of the direction of current through elements of it. Ex: network consisting resistances.

Unilateral Network - A circuit whose operation, behavior is dependent on the direction of current through its elements. Ex: network consisting diodes (allows flow of current only in one direction).

Active Network - A circuit which contains at least one source of energy (voltage/current source). Ex:  op-amps, signal generators. 

Passive Network - A circuit which doesn’t contain any energy source. These networks consist of passive elements only. Ex: resistors, inductors.


Network Theorems

Superposition Theorem
Applicable for linear and bilateral networks.
Stated as, the response in any element of linear, bilateral network containing more than one source is the sum of responses produces by the sources, each acting independently. The response means the voltage across the element or the current in the element.

Steps to apply superposition theorem
Step1: Select a single source acting alone. Short the other voltage sources and open the current sources, if internal impedances are not known. If known, replace them by their internal impedances.
Step2: Find the current through or the voltage across the required element, due to the source under consideration.
Step3: Repeat these steps for all sources.
Step4: Add all the individual effects produced by individual sources.



Thevenin’s Theorem
Any combination of linear bilateral circuit elements and active sources connected to a given load ZL may be replaced by an equivalent circuit consisting of a single voltage source VTH and a series resistor Zeq.

Steps to apply Thevenin’s theorem
Step1: Remove the branch impedance, through which current is required to be calculated.
Step2: Calculate voltage across these open circuited terminals. This voltage is Thevenin’s equivalent voltage VTH.
Step3: Calculate the equivalent impedance Zeq.
Step4: Draw the Thevenin’s equivalent showing the voltage source VTH with the impedance Zeq in series with it. Reconnect the branch impedance ZL. The required current through the branch is,


 

Norton’s Theorem
Any combination of linear bilateral circuit elements and active sources connected to a given load may be replaced by an equivalent circuit consisting of single current source and parallel impedance.

Steps to apply Norton’s theorem
Step1: Remove the branch impedance through which current is required to be calculated and short the branch.
Step2: Calculate current through this circuited branch. This current is Norton’s current IN.
Step3: Calculate the equivalent impedance Zeq.
Step4: Draw the Norton’s equivalent showing the current source IN with the impedance Zeq in parallel with it. Reconnect the branch impedance ZL. The required current through the branch is,




Maximum power transfer theorem
A load will receive maximum power from a linear bilateral network when its total resistance value is exactly equal to Thevenin’s resistance of network as seen by load.